It can display current vehicle information including Engine RPM, Coolant Temperature, Fuel System Status, Vehicle Speed, DPF information, Gear Position, Battery Voltage and Transmission Oil: Diagnose your car’s condition before driving.
It can prevent any issues and save your time!
IROAD DASH CAM X10, T10s2
Note: Also supplies power to dash camera.
Average Fuel Consumption
(Diesel particulate filter)
BELOW IMAGES ARE EXAMPLES OF HOW IT LOOKS ON T10S2 & X10 DASH CAMS
DASH CAMERA NOT INCLUDED
Please make sure to check them before using X-SCANNER
To operate X-Scanner, please turn the ignition on to run “IROAD Smart Manager” app or OBD setting (T10s2).
(Not able to set when ACC ON or KEY ON)
After applying the X-SCANNER Firmware and DB update, please make sure to save the vehicle settings again.
Please enter the vehicle information (Year/Type/Fuel Efficiency etc) based on the vehicle registration card.
There may be some limitations of X-SCANNER function depends on vehicle grade and option.
When Mercedes with “Mercedes me connect” is turned on, “Mercedes me connect service restriction” message may be displayed. But, there is no problem in use. If you install a dedicated Mercedes diagnostic device or other OBD II, the above phenomenon will occur.
For some hybrid vehicles and vehicles that use two fuels together, fuel economy information may differ from the actual.
In cases of electric vehicle, fuel consumption is not supported. But, battery charge rate is supported instead of fuel level.
In some electric vehicles, dash cam starts driving mode when the vehicle is moved only.
The fuel consumption on the X-Scanner may be inaccurate until a calibration occurs.
Some vehicles may require an extra extension cable to install OBD II Scanner. Also, the OBD ll can be pushed inward because of interference when the OBD II scanner is installed.
X-Scanner may not work when the X-Scanner and other company’s OBD are bridged by Y-Cable mode.
Vehicle is equipped with DCT does not provide the transmission oil temperature value, so it is not shown.
Troubleshooting code supports international standard diagnostic code (after 2010).
If the OBD II was set to different vehicle more than 7 times for miscellaneous reasons or changing cars, the X Scanner will not properly function and there will be no compensation in such case. However, there are no limited amounts of numbers to set the OBD II when it is being connected to the same vehicle.
KOBD can be set by mobile application only.
Does not support 24V vehicles.
For more information on X-Scanner compatibility Click Here.